The Combus is a communication protocol that is integral to the KT It uses a four-conductor cable bus to which several expansion modules can be. Controls two doors and easily links to a network Update firmware directly from system workstation Fast operation, up to , baud Ready to go, no DIP. KANTECH SYSTEMS | KT/K Door Controller, 2-Reader, Kilobyte, ” Length x 3″ Width x ” Height, With Accessory Kit, Metal Cabinet with .

Author: Tushakar Mezishura
Country: Central African Republic
Language: English (Spanish)
Genre: Literature
Published (Last): 3 January 2012
Pages: 445
PDF File Size: 7.87 Mb
ePub File Size: 8.33 Mb
ISBN: 871-6-21938-609-4
Downloads: 74278
Price: Free* [*Free Regsitration Required]
Uploader: Mezimuro

Page of 28 Go. KT CABmounted in a dry, secure location.

The Combus is a communication protocol that is integral to the KT Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 of UL, fifth edition. If the lithium battery stops working, return the circuit board to Kantech.

Kantech KT Installation Manual 14 pages. By continue to navigate through this site or by clicking Approve, you consent to the use of cookies on your device as kamtech in our Privacy Notice.

Page 6 Kantdch must first obtain an authorization number. The four Combus terminals of the main panel must be connected to the four Combus terminals or wires of all modules. Does anyone have any ideas? It uses a four-conductor cable bus to which several expansion modules can 30 connected.


By pressing ‘print’ button you will print only current page. Comments to this Manuals Your Name.

Kantech kt – General Access Control Discussion –

Installing The Kt The KT uses high 3000 communication, proper grounding must be provided to ensure proper operation. There are liability issues relating to access control such as Fire code etc.

The KT was communicating via the RS port and you installed a VC to communicate via the RS port; c You were using the KT at a local site and now want to configure it for remote operation. Already have an account?

All specifications were current as of publication date and are subject to change without notice. You need to be a member in order to leave a comment. k


Paying a company a couple of hundred will be well worth it. I am having a similar problem with a kt being connected via USB. Power kanhech are supervised and individually protected against short-circuits and surges by self-resetting PTC. Share this post Link to post Share on other sites. Please refer to the graphic below for a detailed view of their location.

To print the manual completely, please, download it. Posted June 16, Connect the external tamper switch, if used.

I am having issues with it. General Access Control Discussion.


Kantech KT-300 Installation Manual

Don’t show me this message again. Flash memory allows for firmware updates from an EntraPass workstation in just a few minutes. If the Heart led is blinking 3 times you got connection with the pc, you can always check the small yellow led rs or rs will light left side of the controller.

I did a hard reset the way it said to do it in the manual and now all it does is flash 4 times per second hard reset to factory defaults. In the event of a power surge or transient, a module may lock up and cease to communicate with the controller. Table of Contents Pre-Installation Information Connect the battery leads to the battery, and connect the Kqntech transformer.

Posted July 18, Connect the battery leads to the battery. Register a new account. This module allows a maximum of 16 outputs and a maximum of up to 50 mA per output. It says not assigned. Their tech support is extremely helpful.

Can be expanded up to 16 controlled outputs when using a KT-PC module. Got it, continue to print. Enter text from picture: Then, connect the AC transformer.